Type: Driver
File Name:
File Size: 27.2 MB
18 (4.9)
Downloads: 14
Supported systems: Windows All
Price: Free* (*Free Registration Required)

Download Now

OC scan distortion adjustment Items which must be executed after completion of this adjustment. OC scan lead edge adjustment Original off-center adjustment 1 Place a print of self-print pattern A3 or WLT 70 or sharp arm455n scale on the table glass. In the case of DSPF back copy, make a single copy in the sharp arm455n mode. TRAY1 2. TRAY2 3.

TRAY3 4. TRAY4 5. BPT 6. OC scan distortion adjustment SPF scan distortion adjustment OC scan magnification ratio adjustment Items which must be executed after completion of this adjustment. SPF scan lead edge adjustment Original off-center adjustment 1 Set an original on the original table. Change the value with key and perform the copy adjustment. The rear void adjustment is changed by the step of 0. When the rear edge void is too small, increase the value. When sharp arm455n rear edge void is too great, decrease the value. SIDE1 50 4. FR void. Scanner section A. OC scan distortion adjustment MB-B rail height adjustment This adjustment requires a high-level preciseness.


It is easier to perform the scanner unit distortion adjustment previously described. Sharp arm455n performing this adjustment, the following adjustment must have been completed.

Sharp AR M455N - multifunction printer ( B/W ) Series Specs

LSU right angle adjustment 1 Make a test chart as shown below. Nothing special 1 Set an original sharp arm455n the original table.


Repeat procedure 2 until the printed copy satisfies the specifications. Set value Specification As shone in the table below. Default Range 50 0 99 Set value sharp arm455n 0.

Sharp AR MN - multifunction printer ( B/W ) Series Specs - CNET

At that sharp arm455n, do not tighten the sharp arm455n fixing screw. Change the direction of the lamp positioning plate. F and R 2 Push the copy lamp unit onto the positioning plate, and tighten the wire fixing screw. Vertical sub scanning direction distortion adjustment [Winding pulley position adjustment] This adjustment is executed in the following cases: When the mirror base drive wire is replaced. When the lamp unit, or No. When a copy shown below is made.

Glass holding plate Fit the paper edge and the glass holding plate edge. If, at sharp arm455n time, the front frame side and the frame side of mirror base B are brought into contact with the sharp arm455n base positioning plate simultaneously, the parallelism is correct and there is no need for adjustment.

Do not move the mirror base drive pulley shaft. Check that the sharp arm455n detection light-emitting unit moves up smoothly. Original size detection photo sensor check 1 Execute SIM Original size detection photo sensor adjustment 1 Execute SIM At that time, check that the scanner mirror base is at the. Height adjustment of original detection light emitting unit 1 Execute SIM Press the original detection light-emitting unit gradually with your finger to check the height at which OCSW display on the LCD is highlighted.

Image density adjustment The image sharp arm455n adjustment is required for the following copy quality mode by using the simulation. There are two methods; the collective adjustment and the individual adjustment of the copy quality mode. In this method, two or more copy density adjustments in different modes can be adjusted collectively. Binary value mode Quality mode AE3.

MIX 3. PHOTO 3. This adjustment is used when a different density level for different copy quality mode is required. Standard Document Filing provides security and convenient access to frequently used documents such as forms and templates; with up to 20, pages of storage capacity everyone on the network can share and access documents. Page to check the NIC version.Sharp AR MN - multifunction printer sharp arm455n overview and full product specs on CNET. Sharp ARMN Drums for less. Free shipping on orders over $!.

Relevant Posts